46210/46220-0998 <90-00036> PAGE 43
Output Responses:
All commands give the following response:
>ACK POINTS
BELL
Purpose:
Reports if the terminal bell is on or off. Turns bell on or off.
When bell is on, it sounds when a change of alarm status occurs.
Format:
BELL
BELL ON
BELL OFF
Remarks:
The command BELL shows if the bell is on or off. The other
commands turn the bell on or off.
Output Response:
Only the BELL command gives a response and that is to report
if the bell is on or off.
CPM POINT ACTIVATE
Purpose:
Operates a control point.
Format:
CPM # ACTIVATE point number
Remarks:
Point is activated for the time period set by the switch S3 or by
programming (see OPTION and CPM POINT TIME PERIOD
commands).
# can be a range of subgroups from 1 through 4 or the word ALL.
Here are examples:
CPM 4 Control subgroup 4 (control points 49-64)
CPM -3 Control subgroups 1-3 (control points 1-48)
CPM 2- Control subgroups 2-4
CONTINUED . . .
PRINTER SYNTAX
To Next Page
Loading...
