46210/46220-0998 <90-00036> PAGE 35
PRINTER SYNTAX
Y
ou may check the status of alarm points and operate control
points by issuing commands using a dumb terminal, a
personal computer operating as a dumb terminal, or a 46001
Status Monitor.
GETTING STARTED
To issue commands, a dumb terminal or personal computer
operating as a dumb terminal must be connected to the RS-232
master port connections. If the 46210/46220 is not equipped with
an RS-232 interface, one must be installed.
To install an RS-232 subassembly:
1. Open the 46210/46220 (refer to Fig. 28).
FIG. 28 - OPENING THE 46210/46220
462xx-xx REV ____
WARNING:
REMOVE fuse
before removing
or inserting module
Use wrist strap
ESD SENSITIVE DEVICE
POWER
ALARM
uP LED
MSTR
AUX
GREEN = RCV
RED = XMT
Front View
Place Thumb
Here
Side View
CONTINUED . . .
To Next Page
Loading...
