PAGE 46 46210/46220-0998 <90-00036>
Remarks:
This group of commands overrides momentary/latching settings
of switch S3.
# can be a range of subgroups from 1 through 4 or the word ALL.
Here are examples:
CPM 4 Control subgroup 4 (control points 49-64)
CPM -3 Control subgroups 1-3 (control points 1-48)
CPM 2- Control subgroups 2-4
CPM 2-3 Control subgroups 2-3
CPM ALL All control subgroups
List point numbers individually with a comma between them, or
as a group with a hyphen between them, or use the word ALL;
range can be from 1 through 16.
The DLON command latches control points on. The DLOF
command resets the latched points.
The DMON command operates control points for three seconds.
The DMOF command turns latched control points off for three
seconds, then back on.
Input Example:
>CPM 2 DLON 1,3,5
Output Response:
>CPM 2 POINT 1 OPERATE
CPM 2 POINT 3 OPERATE
CPM 2 POINT 5 OPERATE
This example would latch on control points 17, 19 and 21 (points
1, 3, and 5 of subgroup 2).
CPM POINT RELEASE
Purpose:
Resets control points.
Format:
CPM # RLS point number(s)
PRINTER SYNTAX
To Next Page
Loading...
