PAGE 48 46210/46220-0998 <90-00036>
Input Example:
>CPM 1 RST
Output Response:
>CPM 1 POINT 1 RELEASE
CPM 1 POINT 2 RELEASE
CPM POINT SELECT OPERATE
Purpose:
Momentarily turns control points on or off. Also latches control
points on and resets latched points.
Format:
The following commands prepare the control points for opera-
tion:
CPM # SLON point number(s)
CPM # SLOF point number(s)
CPM # SMON point number(s)
CPM # SMOF point number(s)
The following command executes the above commands:
CPM # EXE (or EXECUTE)
Remarks:
This group of commands overrides momentary/latching settings
of switch S3.
# can be a range of subgroups from 1 through 4 or the word ALL.
Here are examples:
CPM 4 Control subgroup 4 (control points 49-64)
CPM -3 Control subgroups 1-3 (control points 1-48)
CPM 2- Control subgroups 2-4
CPM 2-3 Control subgroups 2-3
CPM ALL All control subgroups
List point numbers individually with a comma between them, or
as a group with a hyphen between them, or use the word ALL;
range can be from 1 through 16.
CONTINUED . . .
PRINTER SYNTAX
To Next Page
Loading...
