46210/46220-0998 <90-00036> PAGE 49
The SLON command prepares control points for latching. The
SLOF command prepares the latched points for resetting.
The SMON command prepares control points for operating for
three seconds.
The SMOF command prepares to turn latched control points off
for three seconds, then back on.
Input Example:
>CPM 2 SLON 1,3,5
>CPM 2 EXE
Output Response:
>CPM 2 POINT 1 OPERATE
CPM 2 POINT 3 OPERATE
CPM 2 POINT 5 OPERATE
This example would latch on control points 17, 19 and 21 (points
1, 3, and 5 of subgroup 2).
CPM POINT SET
Purpose:
Operates points at the CPM(s).
Format:
CPM # SET point number(s)
Remarks:
# can be a range of subgroups from 1 through 4 or the word ALL.
Here are examples:
CPM 4 Control subgroup 4 (control points 49-64)
CPM -3 Control subgroups 1-3 (control points 1-48)
CPM 2- Control subgroups 2-4
CPM 2-3 Control subgroups 2-3
CPM ALL All control subgroups
List point numbers individually with a comma between them, or
as a group with a hyphen between them, or use the word ALL;
range can be from 1-16.
PRINTER SYNTAX
To Next Page
Loading...
