PAGE 54 46210/46220-0998 <90-00036>
Output Response:
DISP 1
DISP 1.1 . . FB. . . . .
DISP 1.2 NA. . F . . . .
DISP 1.3 . . . . . . . .
DISP 1.4 . . . . . . . .
DISP 1.5 . . . . . . . .
DISP 1.6 . . . . . . . .
DISP 1.7 . . . . . . . .
DISP 1.8 . . . . . . . .
In the example above, display 1.1 has an unacknowledged
B-level alarm failure (F). Display 1.2 has an unacknowledged
A-level alarm that has returned to normal (N) operation; it also
has an acknowledged alarm failure (F) that still exists.
NOTE: The same reporting is used for both alarms and control points.
To determine if displays are for alarms or control points, see
the PROVISIONING command, which lists the memory
displays where alarm and control point information is stored.
LINEFEED
Purpose:
Reports if the linefeed is on or off. Turns the linefeed on or off.
Format:
LINEFEED
LINEFEED ON
LINEFEED OFF
Remarks:
The command LINEFEED shows if the linefeed is on or off. The
other commands turn the linefeed on or off.
OUTPUT RESPONSE:
Only the LINEFEED command shows a response and that is to
report if the linefeed is on or off.
PRINTER SYNTAX
To Next Page
Loading...
