46210/46220-0998 <90-00036> PAGE 59
Output Response:
SG 1 BBBBBBBBBBBBBBBB 1.1 1.2
CPM 1 DDDDDDDDDDDDDDDD 33.1 33.2
Each line shows the subgroup number, alarm level, and the
location in memory where the data is stored (display 1.1, 1.2,
etc.). For control points the level is always D. For more informa-
tion on the displays, see the DISPLAY command.
QUERY
Purpose:
Gives a report of the 46210/46220’s configuration.
Format:
QUERY
Input Example:
>QUERY
Output Response:
Point latch until transmitted
Point display : 200 ms
ESYS Mode : OFF
Port Protocol : DCP
Port baud : 9600 N,1,8
DCP ID : 1
REVERSE
Purpose:
Reverses the alarm input state from Open = Normal to
Closed = Normal.
Format:
SG # REVERSE
SG # REVERSE #
PRINTER SYNTAX
To Next Page
Loading...
