What to do if Dantherm Fan drain is blocked?
If the drain is blocked in the pipe or drip tray inside the Dantherm Fan unit, check that the drain is not blocked and clean it with water and detergent if required.
How to secure Dantherm Fan front cover?
If the styrene front cover and/or the plastic panel on the drip tray have been unscrewed from the Dantherm Fan unit and not replaced securely enough, check that the plastic panel on the drip tray and styrene front cover have been installed correctly so that they are completely airtight and watertight.
How to adjust Dantherm Fan airflow?
If the Dantherm Fan unit may be running with too high a level of air replacement for the size and use of the house, check that the unit's airflow is appropriate to the size and use of the house by checking the unit's airflow according to the initial adjustment procedure.
General| Brand | Dantherm |
|---|---|
| Model | HCV 5 |
| Category | Air Handlers |
| Language | English |
The power must not be connected until the ducting system has been mounted.
The ventilation system must always be operating!
The purpose of bypass is to cool down the house by leading the cold outside air flow directly into the house avoiding it is heated up in the heat exchanger.
The button will lit when activated and warm, moist extract air will be redirected...
By activating manual operation you are able to shift between 'turned off 'and Fan Step 1 to 4.
This is the control panel which is delivered with every unit. See a description of each button below:
Push this button to active Manual Bypass.
Push this button to activate Automatic Demand mode of the air volume.
Push this button to activate Manual Operation Mode.
In order for home ventilation to operate safely it is necessary to carry out preventive maintenance, e.g. replacing filters and cleaning the unit.
Change the filters when the filter alarm is visible on the control panel (the diode flashes yellow on and off) and the acoustic filter alarm bleeps (once every hour).
To Next Page
