Dantherm HRC 3 User Manual

10
User menu, continue d
Afterheating settings
Step
Action
1
Activate the menu line by pressing CENTER
2
Press RIGHT to navigate to afterheater icon. The afterheater icon
flashes slowly (30/min). Simultaneously T2, T3 and T5 continue to
show the real temperatures in the unit.
3
Press CENTER to navigate to the AFTERHEATER menu.
T
he display shows the latest settings of all three setpoints (T2, T3,
T5) on their respective places. OFF means that the afterheater is
not controlled in accordance with this setpoint.
4
Press CENTER.
The afterheater setpoint for T2 flashes quickly (120/min), and the
afterheater icon flashes.
5
Press UP/DOWN to set the afterheater setpoint T2, and confirm by
pressing CENTER.
6
T3 afterheater setpoint now flashes quickly (120/min) and the af-
terheater icon flashes.
Press UP/DOWN to set the afterheater setpoint T3, and confirm by
pressing CENTER.
7
T5 afterheater setpoint now flashes quickly (120/min) and the af-
terheater icon flashes.
Press UP/DOWN to set the afterheater setpoint T5, and confirm by
pressing CENTER.
8
The afterheater setpoints are now set and the afterheater icon on
the display flashes slowly (30/min) and all temperatures on the
display are again real measurements in the unit.
9
Press CENTER for 3 seconds to leave the menu.
Clock
Week programs and night mode are controlled by means of the clock. The
clock is set as follows:
Step
Action
1
Press CENTER to activate the menu line (the active operation
mode flashes)
2
Press the RIGHT button until the hands of the clock are flash-
ing.
3
Press DOWN and then UP/DOWN to set the time. Confirm by
pressing CENTER, then the week day icon flashes
4
Set the week day by pressing UP/DOWN, and confirm by
pressing CENTER
Continued overleaf

Dantherm HRC 3 Specifications

General

Brand	Dantherm
Model	HRC 3
Category	Remote Control
Language	English