Dantherm HRC 3 User Manual

7
088037 • Version 1.1 • 07.11.2019
User menu
User menus
In the USER MENU you will find the following operating programs and operating info
Set auto no
Set fan speed
(1-4)
Set week pro-
gram (1-11)
Away mode
on / off
Night mode
on / off
Read after
heater
setpoint
(accessory)
Read filter
re-
maining days
Set time
Set after
heater
setpoint
(accessory)
Set filter re-
maining days
(90-360)
Set date
Navigation button
Button
Function
Activates the user menu, a menu point or confirms settings by pressing the
CENTER button.
Navigates between menu points by pressing LEFT or RIGHT on the naviga-
tion button.
Reduces or increases values by pushing UP or DOWN on the navigation
button.
Change fan speed in manual mode: UP or RIGHT navigation button
Short cuts
Brug navigationstasten som beskrevet i skemaet herunder:
Button
Function
Press CENTER for 3 seconds = back to start, leave all menus
Press DOWN for 5 seconds = activate/deactivate bypass/summer-cooling
for 6 hours (BYP6)
Press UP for 5 seconds = activate/deactivate fireplace mode for 7 min.
(FP07)
Press RIGHT for 10 seconds = activate/deactivate installer menu / installa-
tion mode. (only for trained users/installers)
Press CENTER + UP for 10 seconds = back to factory setting of all settings
and setpoints. (Only works in the installer menu)
Press LEFT for 10 seconds = reset pairing
Press and hold the CENTER button for 10 seconds to reset the filter.
The remote control confirms this with an acoustic signal.

Dantherm HRC 3 Specifications

General

Brand	Dantherm
Model	HRC 3
Category	Remote Control
Language	English