Dantherm TKS 60 User Manual

16
Connect controller CC3000 to TKS 60
System Setup
At startup insert SD card in the slot located on the side of the CC3000
controller. This will allow you to select the config file for your TKS 60.
Note: When the SD card is inserted the controller will automatically update firmware.
See instructions in display.
Until the SD card is inserted the controller will remain inactive and the buttons will not function.
For product configuration and advanced use please refer to the user
manual for the CC3000 controller.

Dantherm TKS 60 Specifications

General

Brand	Dantherm
Model	TKS 60
Category	Air Handlers
Language	English