DARCHE DIRTY DEE - Initial Setup and Preparation; Important Notes Before Setup; Step 1: Pole Preparation; Step 2: Middle Pole Insertion

DARCHE.COM.AU
PLEASE NOTE
Prior to first use of the Dirty Dee swag, it is important to remove the mattress from its compression sleeve and allow
it to expand.
Seasoning the swag is not essential but is recommended. For full instructions on seasoning your DARCHE swag, see
How to Season Your Swag (page 7).
Step 1
Unroll the swag onto a flat, well-drained area free of sharp objects that may penetrate the swags PVC floor.
Eachcomposite pole will be dierent in length and all correspond to a specific placement on the swag. Refer to the
labelling on the poles.
Remove the first pole bundle (3x pole sections) from
the pack:
• 2x END section poles (aluminium sleeve on one
endof the pole).
• 1 x MIDDLE section pole (angled aluminium sleeves
on both ends of the pole)
Step 3
Assemble one END section pole into the MIDDLE section angled pole sleeve. The end of the pole will have the
aluminium sleeve to insert the base pin.
Step 2
Feed the angled middle pole through the sleeve on top of the swag and centre the pole.