The Microtubes 900™ is a 900W amplifier equipped
with an all analog preamplifie
r and a Class D Power
Module. The first thing you will notice from the
Microtubes 900 is its unusual control layout:
On the right side you’ll find the clean section
which
is the foundation of your tone.
It features Gain
and Master controls an active 4
band EQ. Along with Low and Treble controls you
will find Low Mids
and Hi Mids control, each knob
with their own 3-way frequency switch
.
On the left side you will find the Microtubes® Engine
which acts as an extra channel that can bring your
clean tone to the next level by helping you cut
through the mix while adding anything from subtle
tube break up, harmonics and natural compression
to obliterating distortion.
DESCRIPTION
The Microtubes Engine™ can be engaged via the
front panel or our own digitally controlled
Intelligent Footswitch™ (jack on rear panel). Besides
engaging the Microtubes circuitry you can hold the
actuator to Mute
the amplifier.
We equipped the power module with some unique
control over the power output and minimum speaker
loads:
The standard mode will deliver 900W RMS at 4
Ω /500W at 8Ω . If you select the 2Ω Mode via the
rear panel switch
the amplifier will deliver 900W at
2Ω /500W at 4Ω and 350W at 8Ω .
This feature allows for maximum power adaptability.
It doesn’t matter the cabinet configuration or power
requirements, the Microtubes 900 will deliver
accordingly.
To Next Page
Loading...
