WARNING
16）LCD Display: Avoid dropping or mishandling the machine to prevent LCD screen
damage and potential harm from leaked liquid crystal. Refrain from heating the liquid
crystal display and avoid scratching the LCD with sharp objects. The touch panel is
also prone to scratching. While the LCD screen typically has more than 99.99% of
effective pixels, there may be a small fraction (0.01%) that cannot be lit normally.
Notice before Installation
For your safety, it is strongly advised not to install or repair the navigation system on
your own as recommended by the manufacturer. Installation and maintenance pro-
cedures can pose risks such as electric shock and other hazards. It is recommended
to entrust all installation and maintenance tasks of this navigation system to an
authorized service center approved by the manufacturer.
Refrain from using the following dangerous installation methods and locations:
1. Avoid installing in a manner that may cause injury to the driver and passengers
during sudden stops or impacts.
2. Don’t install in positions that obstruct the driver's operation, such as the front seat
or the area near the steering wheel and stick shift.
Before cutting holes from the the faceplate on the dashboard panel, ensure that
there is enough space at the rear. Take caution not to damage the fuel cable, brake
cable, electrical components, power lines, or cable communications.
When using screws, make sure they do not come into contact with any electrification
down-lead. Vibrations can potentially damage wires or insulation, leading to short
circuits or other vehicle damage.
To ensure proper installation, use the standard method and required components for
installation. Using non-standard components may result in internal damage or loose
components, leading to product damage.
It can be extremely dangerous if the GPS antenna is positioned near the steering
column or stick shift. Ensure that the product installation does not interfere with
driving.
To Next Page
Loading...