∙ 20 ∙ ∙ 21 ∙
troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
The Cover Lid won’t close.
Something may be stuck
between the handle and the
Donut Mold Plates.
Remove item that is stuck
between handle and Donut Mold
Plate and clean any impacted
surface.
The Donut Maker’s non-stick
coating does not work.
The non-stick coating may be
blocked by dried grease or
crust from a previous donut.
Wipe the non-stick Donut Mold
Plates with a soft, moist towel or
another non-abrasive cleaning
utensil.
To Next Page
Loading...
