Datalogic BA100 User Manual

CBX800 INSTALLATION MANUAL
18
Host RS485 Half-Duplex Interface
The RS485 half-duplex (3 wires + shield) interface is used for polled communication protocols.
It can be used for Multidrop connections with a Datalogic MX4000 Multiplexer, exploiting a proprietary protocol
based on polled mode called MUX32 protocol, where a master device polls slave devices to collect data.
Pinout
Function
RTX+
RS485 Receive/Transmit Data +
RTX-
RS485 Receive/Transmit Data -
SGND
Signal Ground
RTX485+
SGND RTX485-
USER INTERFACE
SGND RTX+
RTX-
CBX800
Figure 19 - RS485 Half-duplex Connections
This interface is forced by software when the protocol selected is MUX32 protocol.
In a Multiplexer layout, the Multidrop address must also be set via serial channel by the Genius™ utility or by the
Host Programming Mode.
ID-NET™ INTERFACE
The following pins are used to connect the ID-NET
TM
interface:
Pinout
Function
Shield
Network Cable Shield
ID+
ID-NET™ network +
ID-
ID-NET™ network -
REF
Network Reference

Datalogic BA100 Specifications

General

Brand	Datalogic
Model	BA100
Category	Adapter
Language	English