Using the Reader
Quick Reference Guide 9
2. Extract the battery pack by slightly rotating the pack
and pulling away from the reader.
To mount the new battery pack reverse the process:
1. Insert the top of the new pack inside the reader’s han-
dle.
2. Rotate the battery pack downward while pressing the
bottom side of the battery pack (to seat securely into
the contact springs) so that the edges of the pack and
the handle board are aligned, while securing the cap-
tive screw in the bottom of the handle.
Using the Reader
Bar Code Reading
Point the reader at the target and pull the trigger to enable
the illuminator (red beam) to decode the bar code label. The
illuminator will remain on until the symbol is decoded.
To Next Page
Loading...
