EasyManua.ls Logo

Datalogic Skorpio-GUN - Page 98

Datalogic Skorpio-GUN
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
07
Datalogic Mobile S.r.l.
Via S. Vitalino 13
40012 - Lippo di Calderara
Bologna - Italy
dichiara che
declares that the
déclare que le
bescheinigt, daß das Gerät
declare que el
Datalogic Skorpio G XXX-YYY-ZZZ
e tutti i suoi modelli
and all its models
et tous ses modèles
und seine Modelle
y todos sus modelos
sono conformi alle Direttive del Consiglio Europeo sottoelencate:
are in conformity with the requirements of the European Council Directives listed below:
sont conformes aux spécifications des Directives de l'Union Européenne ci-dessous:
der nachstehenden angeführten Direktiven des Europäischen Rats:
cumple con los requisitos de las Directivas del Consejo Europeo, según la lista siguiente:
1999/5/EEC R&TTE
Questa dichiarazione è basata sulla conformità dei prodotti alle norme seguenti:
This declaration is based upon compliance of the products to the following standards:
Cette déclaration repose sur la conformité des produits aux normes suivantes:
Diese Erklärung basiert darauf, daß das Produkt den folgenden Normen entspricht:
Esta declaración se basa en el cumplimiento de los productos con las siguientes normas:
ETSI EN 301 489-17 v1.2.1, August 2002: E
LECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM);
E
LECTROMAGNETIC COMPATIBILITY (EMC) STANDARD FOR RADIO EQUIPMENT
AND SERVICES
; PART 17: SPECIFIC CONDITIONS FOR 2,4GHZ WIDEBAND
TRANSMISSION SYSTEMS AND
5GHZ HIGH PERFORMANCE RLAN EQUIPMENT
ETSI EN 300 328 v1.6.1, November 2004: E
LECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM);
W
IDEBAND TRANSMISSION SYSTEMS; DATA TRANSMISSION EQUIPMENT
OPERATING IN THE
2,4 GHZ ISM BAND AND USING WIDE BAND MODULATION
TECHNIQUES
; HARMONIZED EN COVERING ESSENTIAL REQUIREMENTS UNDER
ARTICLE 3.2 OF THE R & TTE DIRECTIVE
EN 60950-1, December 2001: I
NFORMATION TECHNOLOGY EQUIPMENT – SAFETY – PART 1: GENERAL
REQUIREMENTS
Lippo di Calderara, March 9th, 2007
Paola Chientaroli
Quality Assurance Manager

Table of Contents

Related product manuals