Datamax I-class series - Page 13

I-Class
3.2.1 Loading Roll Media
A. Slid
e the Roll Media onto the Media Hub until it reaches the Backstop.
Roll Media
Media Guide
Backstop
Media Hub
B. Route t
he Media under the Media Idler, through the Media Sensor, and then straight out
the front of printer.
Media Idler
Media Guide
Media Sensor
Media
C. Raise then
slide the Media Guide over so that it rests lightly against the edge of the
media.
D. Position the Media Sensor; see Section 3.3.