I-Class
Standard Calibration (continued)
Step
Action Displayed Message Comment
9 Observe the LCD.
GAP MODE
CALIB
RATION COMPLETE
Or, for reflective media:
REFLECTIVE MODE
CALIBRATION COMPLETE
Or, for continuous media:
CONTINUOUS MODE
CALIBRATION COMPLETE
The calibration was
success
ful if
CALIBR
ATION COMPLETE
appears.
(If, however, another
message was displayed
see Note 1, below.)
10
Press the
Key three
times to exit the menu.
Users of circular or
irregularly shaped die-cut
media see Note 2 before
proceeding.
If using gap, notch or
reflective media, press and
hold the FEED Key. Allow
at least one label to
advance from the printer
before releasing the key.
READY
T
he printer is ready.
If
this calibr
ation was
unsuccessful, go to
Section 5.2.2.
Notes:
(1) WAR
NING LOW
BACKING is a normal
message when
calibrating notched media
or media with
transparent backing; see
Section 6.1.2 for other
possible messages.
(2) If using circular or
irregularly shaped die-cut
labels, reposition the
Sensor Eye Mark over the
widest part of a label.
To Next Page
Loading...
