I-Class
5.7.1 Updating from Ready Mode
Application Version 2.091 (or greater) Update Procedure
Step
Displayed Message Action Comment(s)
1
READY
Using the DOS copy
command (where
“filename” is the program
to be loaded and “lpt1” is
the selected interface
port), enter the
following:
copy filename lpt1:
As an example, this would
be entered as:
copy i4212_1105.zg lpt1
(Where “lpt1” can differ to
include another port, as
equipped.)
The Ready Indicator will
flash as data is received.
2
UPGRADING SOFTWARE
No action required.
The new application is being
stored and verified.
3
4214
11.05 03/26/2008
No action required.
The printer has reset and is
displaying the new firmware
version.
4
READY
No action required.
The new application is
running.
Note: If UNCALIBRATED
is displayed, see Section 5.2.
To Next Page
Loading...
