I-Class
Fault Messages (continued)
Fault Messages
Displayed Message Description Action(s)
OUT OF STOCK
The printer cannot detect
media.
Try the following procedures:
• Load media. Ensure that the
labels are passing through the
Media Sensor and, if
necessary, readjust the Media
Sensor over the TOF mark;
see Section 3.3. Also, if using
media with large gaps, adjust
the PAPER OUT DISTANCE
(see Section 4.2.2); or,
• Calibrate the printer; see
Section 5.2.
POSITION FAULT
One of the following has
occurred:
• An update was made
to the application
version;
• The printer was
powered-off or reset
during a ribbon, out of
stock or TOF fault; or,
• The printer was unable
to complete the
calibration.
Try one of the following
procedures:
• Press the FEED Key then clear
any related fault condition; or,
• Calibrate the printer; see
Section 5.2.
PRESENT SENSOR FAULT
The printer cannot detect
the Present Sensor.
Ensure that the option is
installed properly. Try cycling the
power OFF and ON. If the fault
does not clear, call for service.
PRINT ENGINE FAULT
The printer has detected a
problem within the print
logic.
Try cycling the power OFF and
ON. If the fault does not clear,
call f
or service.
RAM FAULT
The system has detected a
memory failure.
Try cycling the power OFF and
ON. If the fault does not clear,
call f
or service.
To Next Page
Loading...
