2
Installing the Thermal Transfer Assembly
Position the Thermal Transfer Assembly in
the printer as shown and secure using the
three provided Screws.
Setup and Configuration
In order to use thermal transfer printing the printer must be loaded with ribbon and the ‘Select Media
Type’ menu function must be set to ‘Ribbon Transfer’. For proper loading of ribbon see the ‘Ribbon
Loading’ instructions in the Operator’s Manual. Follow the steps below to set the printer to ‘Ribbon
Transfer’.
Verify the printer is in the ‘Ready Mode’
Press the button. The ‘Select
Media Type’ menu function should be
displayed, press the button.
Using the button scroll to ‘Ribbon
Transfer’. Press the button to select the
displayed setting, an asterisk will appear to the
left of the setting indicating that it is selected.
Once you have selected the desired setting
press the button repeatedly until the ‘Save
Changes’ message is displayed. Press the
button to save the changes or the button to
discard the changes.
To Previous Page
Loading...
Need help?
General
