V130108E iBoot-G2 Page 11
Linkback URL
: This setting allows control of the hotlink displayed on the Goodbye page. It allows use of
the public IP address or DNS name instead of the internal IP Address of the iBoot-G2, which is the default
setting. If this setting is left blank, the hotlink will be the IP Address of the unit. Enter up to 128 characters.
Telnet Port:
This setting is used to allow access to the iBoot-G2 via telnet by ports other than standard 23.
DxP Port:
This setting is used to allow access to the iBoot-G2 via Dataprobe Exchange Protocol (DxP) via
ports other than standard 9100.
Note: All of the TCP/IP Settings require a reboot of the iBoot-G2, after clicking Save. A Reboot
button will appear at the bottom of the page. The new settings will not take effect until the unit is
rebooted. Reboot will not affect the power position of the iBoot-G2. Upon Clicking Reboot, the
Googbye page is displayed with a link to re-login.
To Next Page
Loading...
