V130108E iBoot-G2 Page 20
11. Troubleshooting
The iBoot-G2 has a recessed pushbutton switch in the event the unit is not performing as expected. Use
the pushbutton as follows:
Action Result
Momentary Soft Reset. Will not change outlet status.
5 Seconds push Reset to Factory Defaults. Hold the button in
until the Outlet LED is blinking, then release.
Hold in while and
Power up the iBoot
Recovery Mode. Allows upload of new
firmware to the current IP Address. Will
recover to the Factory default IP Address
192.168.1.254 if the database has been
corrupted.
To Next Page
Loading...
