V130108E iBoot-G2 Page 18
set event <1-8> date
<mm/dd/yyyy>
This command is used to set the scheduled action’s start
date.
set event <1-8> time <hh:mm> This command is used to set the time the scheduled action
will occur in 24 hour format.
set event <1-8> action <on |
off | cycle>
This command is used to set the scheduled action.
set event <1-8> repeat <day |
hour | minute>
This command is used to set how often the scheduled action
will repeat.
set event <1-8> mult <0-999> This command sets how often the event will repeat, the
number of increments (as set by the command above) before
the next event.
del event <1-8> This command deletes the specified event
Prompts
The CLI will use the following prompts:
User>
This prompts the user to enter his user name (user or admin).
This is the first prompt that the user is presented with.
Password>
This prompts the user to enter his password.
iBoot >
This is the prompt that will be displayed after the user has
successfully logged in.
iBoot Reboot Required>
This is the prompt that will be displayed whenever there have
been changes made that require a reboot. This prompt will
remain the active prompt until the iBoot-G2 has been
rebooted.
To Next Page
Loading...
