iBoot Page 12
Setup Page
The setup page consists of four sections. Each time a setting is
changed click on apply for that section to save the changes in
iBoot. If the IP address is changed via this page, the iBoot will
require rebooting to install the new address. This is done by
removing the power cord on iBoot from its power source, not
clicking on OFF from the main screen.
Device Name: Set a 20 Character name to be
displayed on the Main Page.
Cycle Time: 0 to 999 seconds power cycle time
IP address: Power Cycle iBoot if this is
changed
Subnet Mask: Change if required
Gateway: Change if required.
Ping Address: Enter the IP address of the
device to be ping'ed.
Ping Frequency: Enter 1 to 999 seconds
Action: select from
♦ None (Auto Ping not used)
♦ Power On
♦ Power Off
♦ Power Cycle
Change Password by entering the old
password then the new password twice.
Remember your Password.
Remember to click Apply for each section
you are changing.
Home: Return to the main screen
To Next Page
Loading...
Need help?
General
