Dataprobe iBootBar - Page 14

iBootBar Page 14
ibootbar_v1.2x
get events
This will display a list of all events as shown:
Events: EventOne
EventTwo
EventThree
EventFour
Events will be displayed in the order they are in
the list. They will NOT be sorted.
get event < name >
This command is used to get the details of a
single event. The format is as followes:
Date: 11/27/2007 at 12:00
Action: On
Control: Outlet1
Repeats: Never
Network Commands Description
The following commands require administrative rights
get network
Display current ipmode, ipaddress, subnet,
gateway parameters
ß
set ipmode <arp-ping/static/dhcp>
Set the mode of setting the IP address of the
iBootBar.
ß
set ipaddress <dotted decimal>
Set the current IP address. ipmode must be set
to static to use this command.
ß
set subnet <dotted decimal>
Set the Subnet Mask
ß
set gateway <dotted decimal>
Set the Gateway.
get web
Display current web enable, web port and ssl
enable parameters
ß
set web enable <yes/no>
Enable or Disable the Web Server.
ß
set web port <1-65535>
Change the Web Server IP port.
ß
set web ssl <yes/no>
Select SSL security for the Web Server. Setting to
yes requires https:// access and defaults port to
SSL standard 443. Setting to no requires http://
access and defaults port to HTTP standard 80.
get telnet
Display current telnet enable, telnet port
parameters
ß
set telnet enable <yes/no>
Enable or Disable Telnet Server
ß
set telnet port <1-65535>
Change the Telnet Server IP port.
get snmp
Display current SNMP parameters
ß
set snmp writecommunity <name>
32 characters max
ß
set snmp readcommunity <name>
32 characters max
ß
set snmp <n> ipaddress <dotted decimal> Set up to <n>=1-4 SNMP manager addresses
ß
set snmp <n> enable <yes/no>
Enable or Disable SNMP for manager <n>
get upload enable
ß
set upload enable <yes/no>
Enable or Disable firmware uploading capability.
get email
Setup email delivery of status and alarm changes.
Set the server address, return address, username