Dataprobe iPIO-8 - Dataprobe iPIO Communications Options; Web Browser Access; Telnet and CLI Access; SNMP Network Management

iPIO-2816_v180808n iPIO-2, iPIO-8, iPIO-16 Users Guide Page 11
5. Communications Options
The iPIO units have a number of means of communication.
Factory Defaults:
IP Address 192.168.1.254
User Credentials
Two user types are supported Administrator and User. The chart below details the available functions of
each type.
User Type
Default Username / Password
Access
Administrator
admin / admin
View, Control and Setup
General User
user / user
View and Control
5.1. Web Browser
Point your browser to the IP address of the iPIO unit and enter the credentials as set. The web pages
provide status information on the inputs and outputs of the iPIO, as well as provide configuration for the unit.
Open a browser to the default or current IP address of the unit. Enter the default username and password.
See Sections 6-8 for complete web browser details
5.2. Telnet
The system supports the Telnet communications protocol for basic setup only.
Connect via Telnet client to the IP address of the iPIO. Enter the credentials as set.
Hello... connected to iPIO-X!
Connected to Telnet Session 1
User> admin
Password> *****
Telnet Factory Default
Port 23
See Section 9
for Telnet and CLI details
5.3. SNMP
The iPIO is SNMP manageable. Up to four SNMP managers can be defined for the purpose of delivering
status Inform messages.