iPIO-2816_v180808n iPIO-2, iPIO-8, iPIO-16 Users Guide Page 12
SNMP Factory Defaults
Read Community: public
Read/Write Community: private
Notification Timeout: 1 second
Notification Retry Count: 3
Lead Configuration Change: 0 seconds
Download the MIB from the iPIO support pages at http:dataprobe.com/support-ipio
The iPIO is configurable for what events trigger SNMP Traps. See section 7.5 SNMP Setup
• Input. Email on any input change
• Relay. Email on any relay change
• Communication. Email on any change in communication status to the remotes.
• Configuration. Email on any configuration change.
5.4. Email Notifications
The iPIO will send email for a number of events. Up to two email addresses can be specified to receive
emails. The types of events that generate emails are also configurable. See section 7.3 Email Setup
. The
events that can generate emails are:
• Input. Email on any input change
• Relay. Email on any relay change
• Communication. Email on any change in communication status to the remotes.
• Configuration. Email on any configuration change.
Email Syntax for input change
From: <your from account>
Date: Thu, Oct 3, 2013 at 5:14 PM
Subject: Input Change
To: <your to address>
<Location Name of iPIO>
Input <input number> <input name> is <state name>
Example:
From: <mydataprobe@comcast.net>
Date: Thu, Oct 3, 2013 at 5:14 PM
Subject: Input Change
To: testlab@dataprobe.com
Shop Floor - Houston
Input 16 Back Door is Open
Other emails use similar syntax.
To Next Page
Loading...
