Dataprobe iPIO-8 - Telnet and CLI Access for iPIO; Telnet Commands and Usage

iPIO-2816_v180808n iPIO-2, iPIO-8, iPIO-16 Users Guide Page 24
9. Telnet and CLI
The system supports the Telnet communications protocol for basic setup only.
Connect via Telnet client to the IP address of the iPIO. Enter the credentials as set.
Hello... connected to ipIO-X!
Connected to Telnet Session 1
User> admin
Password> *****
Telnet Factory Default
Port 23
Command
Description
Factory Default
get network
Get network IP settings
ipIO-X> get network
MAC Address: 00:0D:AD:02:57:87
IP Mode: Static
IP Address: 10.10.10.62
Subnet: 255.255.255.0
Gateway: 10.10.10.7
DNS1: 0.0.0.0
DNS2: 0.0.0.0
Ok
ipIO-X>
Note: DNS not used in this version
get mac
Displays the MAC address
set ipmode <static|dhcp>
Sets the IP Mode
Static: The IP address is set manually
DHCP: The IP Address is set by DHCP Server
static
set ipaddress
<xxx.xxx.xxx.xxx>
Sets the IP Address in dotted decimal
192.168.1.254
set subnet
<xxx.xxx.xxx.xxx>
Sets the subnet mask in dotted decimal
255.255.255.0
set gateway
<xxx.xxx.xxx.xxx>
Sets the gateway in dotted decimal
0.0.0.0
set telnet port <xxxxxx>
Sets the telnet port (0-65535)
23