Datatool DT202 - To Adjust the Arm;Disarm Tone; To Adjust the Automatic Rearm; To Adjust the Passive Arming Time

Datatool is a brand of Scorpion Automotive Ltd
Scorpion House, Drumhead Road, Chorley North Business Park, Chorley, Lancashire, England. PR6 7DE
Tel: +44 (0) 1257 249928 E mail: info@datatool.co.uk Web: http://www.datatool.co.uk
DT202 Operation Guide Revision 1 24-07-2023
9
Programming Guide
To customise the DT202 features to the user preferred options follow the programming
guides below.
To adjust the arm/disarm tone
1. Disarm the DT202.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons on the remote control.
4. After 3 seconds the DT202 will start to chirp loudly. Release the remote control buttons
after the first chirp, if you miss the correct chirp wait for the alarm to exit programming
mode after the seventh chirp or turn off the ignition a loud chirp will be given to indicate
programming has been exited.
5. Once programming mode is entered the DT202 will bleep a specified number of times
to indicate the current setting, the LED will flash the current setting repeatedly.
6. Press the Arm/Disarm or Programming button on the remote control to cycle through
the tone options:
• Off (1 Bleep) (Default)
• Quiet (2 Bleeps).
• Loud (3 Bleeps).
7. Turn off the ignition to exit programming and save the new setting a loud chirp will be
given. If the ignition is not switched off within 30 seconds the DT202 will give a loud
chirp and the currently selected setting will be stored.
To adjust the Automatic Rearm
1. Disarm the DT202.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons on the remote control.
4. After 3 seconds the DT202 will start to chirp loudly. Release the remote control buttons
after two chirps, if you miss the correct chirp wait for the alarm to exit programming
mode after the seventh chirp or turn off the ignition a loud chirp will be given to indicate
programming has been exited.
5. The DT202 will bleep a specified number of times to indicate the current setting, the
LED will flash the current setting repeatedly.
6. Press the Arm/Disarm or Programming button on the remote control to cycle through
the automatic rearm options:
• Off (1 Bleep) (Default).
• On (2 Bleeps).
7. Turn off the ignition to exit programming and save the new setting a loud chirp will be
given. If the ignition is not switched off within 30 seconds the DT202 will give a loud
chirp and the currently selected setting will be stored.
To adjust the Passive Arming time
1. Disarm the DT202.
2. Turn on the ignition.
3. Within 10 seconds, press and hold both buttons on the remote control.