Datecs FP-2000 User Manual

Fiscal Printer DATECS FP-2000 Version 3.10
“I” Gives us the option to read values, set earlier with command 43. After the letter “I” only
one more symbol follows which coincides with some of the above.
Text A text string:
 If <Item> is from ‘0’to ‘7’ - the text of the header / footer line (up to 48 symbols). ‘0’ to ‘5’ are
header lines (set using command 98), ‘6’ and ‘7’ are footer lines.
 If <Item> = ‘B’ - A number – the height of bar code in pixels.
 If <Item> = ‘C’ - One symbol value ‘0’ or ‘1’, where “0” forbids and “1” permits the automatic
cutting of the receipt.
 If <Item> = ‘D’ - The print darkness (1 to 5).
 If <Item> = ‘E’ – Returns Enable,Rate, where Enable is Disable / enable flag and Rate is current
exchange rata EUR / LEKI.
 If <Item> = ‘L’ Syntax <Enabled>,<Height>
Enabled ‘0’ or ‘1’, where ‘1’ means, that logo printing is enabled.
Height Graphics logo height in lines (0.125 mm). A number from 8 to 96.
 If <Item> = ‘T’ – One symbol: ‘0’ or ‘1’, where ‘0’ disables and ‘1’ enables printing of accumulated
VAT values in a non-invoice type fiscal receipt.
 If <Item> = ‘X’ – One symbol: ‘0’ or ‘1’, where ‘1’ disables and ‘0’ enables automatic cash drawer
pulse in commands 53 (35H) and 70 (46H).
2CH (44) ADVANCING PAPER
Data field: [Lines[,Option]]
Response: None
Lines Advancing paper measured in lines. The programmed line count cannot be greater than 99 (1 or 2
bytes). If the parameter is not there the default setting is 1 line.
Option Defines which paper to be advanced:
“0” No effect
“1” The receipt paper roll is advanced
If the second parameter is missing the default setting is to advance only the receipt paper roll.
2DH (45) CUTTING OFF PRINTED DOCUMENTS
Data field: None
Response: Result
Result The result from the execution of the command:
“P” Successful cut off
“F” The automatic cutter has blocked.
The command causes the cutting off of the printed, ready document. It must be considered that the program must
advance the paper with at least two lines or the document will not be cut off correctly. If the printer is in the “automatic
cut off” mode it positions the paper itself and the command becomes redundant.
When the printing mechanism blocks for some reason, the paper roll must be taken out of the cutter mechanism and
the command must be executed again. This will position the blade in the extreme right-end of the mechanism.
2F(47) DISPLAYING A TEXT ON THE UPPER LINE OF THE DISPLAY
Data field: Text
Response: None
Text A text of up to 20 symbols which is sent directly to the display. Prior to this a command for the
positioning and clearing of the upper line. If a fiscal receipt is opened and SW4 is OFF the
command is rejected.
30H(48) OPENING A FISCAL CLIENT’S RECEIPT
Data field: <OpCode>,<OpPwd>,<TillNum>[,<Invoice><Num>]
Response: FReceipt
OpCode Operator’s number (1 to 16)
OpPwd Operator’s password (4 to 8 digits)

Datecs FP-2000 Specifications

General

Brand	Datecs
Model	FP-2000
Category	Printer
Language	English