18 FP-550F
operator (owner). This is also the status in which the device is kept in the warehouse of
the manufacturer.
The following commands are performed in the order in which they are presented:
83 (53H) and 96(60).
C) Status when presenting the device to the client
In this functional status the header and the footer are set - the beginning and the end of
each receipt. The header contains information on the owner (name of the company,
address, BULSTAT etc.) while the footer is usually a short advertisement text.The com-
mand 43 (2BH) is performed as many times as is the number of printed lines.
D) Tutorial mode
The fiscal printer is in this status prior to fiscalization. Receipts can be issued but it
must be born in mind that they will bear the mark “non-fiscal”. The generation of a
daily turnover report with clear but it will not be saved into the fiscal memory. A tax
registration number is also entered but not into the fiscal memory and is subject to
change. The clearing of the memory does not cause an entry in the fiscal memory. The
clock may be set arbitrarily.
R) A fiscalized printer
In this functional status clients receipts may be issued and they will be marked “fiscal”.
The daily report and clear is registered in the fiscal memory and the setting of the date
is possible only ahead in relation to the last entry in the fiscal memory. The tax registration
number is registered in the FM and cannot be changed from this point on. It is
IMPOSSIBLE for the printer to exit the fiscal mode without changing the fiscal memory.
The tax registration number of the owner of the device must be know prior to fiscalization
(command 98(62H) after which the command 72(48H) must be executed.
R) Irrecoverable error in the fiscal printer
This is the status of the printer when a serious technical or logical mistake has occurred
as well as in case of fiscal memory failure. After switching ON the device in this mode
a bold sign “FATAL ERROR:4” appears. The printer does not perform commands for
opening fiscal receipts as well as documents, which save data entries into the fiscal
memory. Only diagnostic commands and periodic reports can be executed. Clearing
the RAM and placing a new fiscal memory module must be performed because the
module used before the error is now switched to the READ ONLY mode. ALL THESE
OPERATIONS MUST BE PERFORMED BY AN AUTHORIZED SERVICE
SPECIALIST.
The events, which can bring the printer to this state, are:
- Impossibility to make a correct entry in the fiscal memory;
- Invalid control sum, tax number, serial number, reg. No. of the fiscal memory or
To Next Page
Loading...
