EN Dateq BCS70 Manual Safety instructions 2
Safety instructions
1 All safety instructions, w arnings and operating instructions must be read first.
2 All w arnings on the equipment must be heeded.
3 The operating instructions must be follow ed.
4 Keep the operating instructions for future reference.
5 The equipment may never be used in the immediate vicinity of w ater; make sure that
w ater and damp cannot get into the equipment.
6 The equipment may only be installed or fitted in accordance w ith the manufacturer's
recommendations.
7 The equipment must be installed or fitted such that good ventilation is not obstructed in
any w ay.
8 The equipment may never be installed in the immediate vicinity of sources of heat, such
as parts of heating units, boilers, and other equipment w hich generates heat (including
amplif iers).
9 Connect the equipment to a pow er supply of the correct voltage, using only the cables
recommended by the manuf acturer, as specified in the operating instructions and/or
show n on the connection side of the equipment.
10 The equipment may only be connected to a legally approved earthed mains pow er
supply.
11 The pow er cable or pow er cord must be positioned such that it cannot be w alked on in
normal use, and objects w hich might damage the cable or cord cannot be placed on it
or against it. Special attention must be paid to the point at w hich the cable is attached to
the equipment and w here the cable is connected to the pow er supply.
12 Ensure that foreign objects and liquids cannot get into the equipment.
13 The equipment must be cleaned using the method recommended by the manufacturer.
14 If the equipment is not being used for a prolonged period, the pow er cable or pow er
cord should be disconnected from the pow er supply.
15 In all cases w here there is a risk, follow ing an incident, that the equipment could be
unsaf e, such as:
• if the pow er cable or pow er cord has been damaged
• if foreign objects or liquids (including w ater) have entered the equipment
• if the equipment has suffered a fall or the casing has been damaged
• if a change in the perf ormance of the equipment is noticed it must be checked by
appropriately qualified technical staff.
16 The user may not carry out any w ork on the equipment other than that specified in the
operating instructions.
To Next Page
Loading...
