Set Timer 1- OFF 3
Set the completion time of the rst run time sequence
Select the Set Timer 1- OFF position on the selector switch. A
number ‘3’ will appear on the left of the screen.
This time is factory pre-set to 8am. Proceed as per (a) in the ‘Set
Clock’ instruction to change time.
Set Timer 2- ON
4
Set the completion time of the second run time sequence
Select the Set Timer 2- ON position on the selector switch. A
number ‘4’ will appear on the left of the screen.
This time is factory pre-set to 5pm. Proceed as per (a) in the ‘Set Clock’
instruction to change time.
To disable this timer please refer to selector switch position 2 above.
Set Timer 2- OFF
5
Set the completion time of the second run time sequence
Select the Set Timer 2- OFF position on the selector switch. A
number ‘4’ will appear on the left of the screen.
This time is factory pre-set to 11pm. Proceed as per (a) in the ‘Set
Clock’ instruction to change time. To disable this timer, see notes on
selector switch 4.
Automatic ON 6
Filtration system switches on and off automatically according to your
set times
Select the Automatic ON position on the selector switch. A number
‘6’ will appear on the left of the screen.
Manual ON 7
Over-rides the automatic time clock settings & switches ltration
system ON
Select the Manual ON position on the selector switch. A number ‘7’
will appear on the left of the screen.
NOTE: Chlorination will be constant until turned OFF or back to
Automatic ON. Over chlorination may occur if left for long durations
OFF 8
Over-rides the automatic time clock settings & switches ltration
system OFF
Select the OFF position on the Selector switch. A number ‘8’ will
appear on the left of the screen.
NOTE: Filtration & sanitisation will cease. Not recommended for
long durations.
To Next Page
Loading...
Need help?
General
