Page 9 of 12
THERMATIC
®
FAN WIRING TO THE DIGITAL CONTROLLER
Please follow the instructions 1&2 below if you are using the Davies
Craig Universal Fan Fitting Kit (Parts #1000, 12V; #1001, 24V).
1. Cut the ring terminal off the black wire (85) from the Fan wiring loom to a sufficient
length, this wire (with relay) to be joined with the black/green wire from the Digital
Controller.
2. Cut the green wire, then join sufficient length of wire to connect to battery positive
as shown in the diagram below (86).
Note: To wire the controller for duel fan operation repeat the wiring instructions above
for a second relay (not supplied). Pin 85 on both relays should be connected to the
green wire with black stripe from the controller. We recommend getting a second Davies
Craig Universal Fan Fitting Kit (Parts #1000, 12V; #1001, 24V) for proper fan
installation.
Figure 6: Fan Controller Wiring Diagram
To Next Page
Loading...