4
Hardware (Included)
Some of the hardware is optional based on how the sensor suite is assembled and
installed.
Note: If any of the hardware components are missing or not included, contact Customer
Service toll free at 1-800-678-3669 about receiving replacements.
Tools for Setup
• Wire cutter
• Small Phillips-head screwdriver (electric if possible)
• Adjustable wrench or 7/16" wrench
• Compass or local area map
• Ballpoint pen or paper clip (or other small pointed object)
• Drill and 3/16" (5 mm) drill bit (if using lag bolts)
• Small hammer (if installing optional bird spikes)
1/4" Flat Washers
1/4" Lock Washers
1/4" Hex Nuts
Bird Spikes (15)
U-Bolts
Backing Plate
.05" Allen
Wrench
1/4" x 3" Lag Screws
#4 x 1-1/8"
Machine Screw
#4 Tooth
Lock Washer
#4-40 Hex Nut
Cable Ties
To Next Page
Loading...
