Dawlance DWT 1775 PL - Drainpipe Installation and Usage; Water Inlet Connection

05 06
How to use drainpipe
Before using
1.the drainpipe must be hanged during use, the
height is not more than 1.2m to avoid leakage or stop,
if drain a long time, the machine will stop running.
2. You can adjust the situation of the elbow bend
pipe to change the height of the drainpipe.
3. Do not extrude the drainpipe to ensue drain smoothly.
Drainpipe
Elbow
Less than 1.2m
Water inlet installation
Before using
Tap selection
Suitable tap
Not suitable tap
1. Swing the inlet hose gently to conrm if it is
fastened.
2. After installation,open the tap and check if
it leaks.
3. Do not bend the inlet hose with overstrain.
4. Before each usage,check the connection
between inlet hose connector and the tap.
Make sure they are rmly tted to prevent
dropping from improper installation position.
Inlet valve connector
Inlet hose nut
Water absorption cushion
Connect the inlet hose with the washing machine
Check the connection between inlet
hose connector and the tap
1. Do not take off the water absorption cushion. Please
check if the cushion is dropped or damaged before
each usage. If it is, contact the seller immediately.
2. Put the inlet hose nut on the inlet valve connector.
3. Fasten the inlet hose nut and swing it gently to make
sure if it is suitable.
The front end should be longer than 10mm. The tap exit end
face should be at and smooth, if not le it to avoid leakage
Cautions: When install the washing machine, please use the new hose assy along with the washing
machine, old hose assy can not reuse.