www.Day6Outdoors.com Page 15
If the camera is not ready to record, the status line will give one of the
following messages:
Message Condition
Start on MM/DD/YYYY Camera is waiting on a user specified
“start delay” to expire, and will begin
recording on the date shown.
Skip until HH:MM AM/PM Camera is in a Mid-day Skip period and
indicates the time of day it will restart
recording.
Start at Dawn Camera is in “Light Based” mode and has
detected that it is too dark to operate.
Start at HH:MM AM/PM Camera is in “Time Based” mode and is
not currently schedule to run.
Disk Full – Cannot Start Shown when the camera initializes with
less than 0.1 Gb of free space.
The bottom two lines of the status page show the amount of remaining storage
(7.4 Gb Free in the example) on your memory card, the proportion of battery
life remaining in the active battery bank, and the time and date. Note that
when the storage space falls to 0.1 Gb, the oldest TLV file, (even if it is the only
one), will be deleted, and a new file created.
To Next Page
Loading...