MIRcat OPERATION
•
D11-00028-02-A Page 15 of 54
5. Power Supply
Figure 9. MIRcat Power Supply (AC-DC converter)
The power supply connects to the back panel of the MIRcat laser head. It converts the local AC power to the
DC voltage and current required for safe operation of MIRcat. It accepts AC input voltages in the range 90-
264 VAC, and 47-63 Hz. Ensure the cable is firmly seated and secured on the back panel before turning on
the unit. The power cord can be changed to match local receptacles.
CAUTION: Never unplug the Power Supply connector while the laser is operating and the
computer is communicating to the system. Damage to the laser can occur if power is removed
during operation or tuning.
To Next Page
Loading...