MIRcat OPERATION
•
D11-00028-02-A Page 35 of 54
Step and Measure Mode
The Step and Measure Mode allows the user to enter a Start, Stop wavelength/wavenumber, Step size in
the selected units, enter number of scans or select infinite. The laser will tune to the Start wavelength or
wavenumber, turn ON for the preset Internal Trigger Step Time, then turn OFF for the preset Internal
Trigger Step Delay Time, and then scan to the next step. Once the Start Scan button is depressed, the menu
changes and allows the user to monitor progress of the programmed scan. The Internal Trigger Time
parameters are set in the Laser Settings menu.
To Next Page
Loading...