MIRcat OPERATION
•
D11-00028-02-A Page 39 of 54
Above, Module 2 is active, but the Light Valid light is not on while it pauses during the set Off Time. Now the
Light Valid button is on while the laser emits. An Audio beep can be heard if selected in the Settings menu.
The other option is to set the Manual Scan mode under the Setting menu. The laser will tune to the
programmed position. Light will be on for the programmed dwell time and wait for the user to click the
Manual Step button to allow the laser to tune to the next programmed step. See below.
To Next Page
Loading...