Daymak Tofino X - Charging Your E-Bike

13
Charging your E-Bike
Charging your e-bike is a simple process. You require the following:
• The charger that came with your e-bike.
• A 110V household electrical outlet.
Charger Warning
Only use the chargers that were supplied with your e-bike. Using chargers that do not have
specicaons idencal to those which came with the e-bike could irreparably damage
your e-bike’s baery and electrical systems, and may cause injury.
To charge your e-bike, follow these steps:
1. Turn o the e-bike.
2. Plug the male end of the charger cable into the charging slot on the e-bike.
3. Plug the other end of the charger power cable into your wall socket. This should be
a 110v household electricity supply. You can also use a portable generator, if necessary,
but make sure it provides 110V current.
4. Allow the e-bike’s baery to charge for the appropriate amount of me .
5. Disconnect the charger when the LED light on the charger is green. The baeries
have been fully charged.
If your charger’s LED status light does not change from red to green over an extended
period of me, for perhaps more than 6 hours, and the baery is very hot, the baery
or charger may need replacing. Stop charging and bring both to your Daymak dealer
immediately. Do not charge the baery.