25
Maintenance and
Troubleshooting
This secon outlines problems you may have and soluons you may be able to use.
Many of the parts in this product are not user-serviceable and should be repaired by
trained professionals. This is especially true of the electrical systems and the mechanical
components. Alteraon of these components voids the warranty.
Tire Pressure
Maintain the air pressure in your res at the appropriate level. If the air pressure is too
low, your e-bike’s performance will suer and it will become damaged more easily.
Cold weather and lower temperatures will cause the air pressure in your res to drop, and
warmer weather will cause it to increase, even if there are no leaks in the re tube. To
replace the air in your res, follow this procedure:
1. Idenfy the required pressure by examining the text along the side of the re rim.
This text should indicate the recommended pressure for your re.
2. Locate the air valve on the inner surface of the re rim.
3. Remove the valve cap and place in a secure locaon.
4. Place the nozzle end of an air pump (hand-power or mechanical) over the valve.
5. Pump up the air in the re, being careful not to let the pressure go above the level
prescribed on the side of the re wall.
6. Remove the pump nozzle from the air valve without allowing much air to escape
from the re.
7. Replace the valve cap on the air valve.
Maintaining the proper air pressure will allow you to travel much further on a single
charge, because the motor will not have to work as hard to move the e-bike.
To Next Page
Loading...
Need help?
General
