22
P10: Power Modes: This determines if the Throle works, Pedal Assist Works, or Both.
0 = Pedal Assist only Works / 1 = Throle Only works / 2 = Pedal Assist and Throle Works
P11: Pedal Assist Sensivity: Determines how much pedaling has to be done before the
PAS kicks in. 1 = Least Sensive / 24 = Most Sensive
P12: Pedal Assist Starng Strength: Determines how much power is given inially from the
start of pedalling. 1 = Least Power / 5 = Most Power
P13: Magnec Plate Seng - Not Applicable on this model
P14: Controller Current - This sets the amount of power going into the controller. The
Default is 12A. Modiying this higher than the default may ruin the controller and should
not be tampered with. Any damage done in this manner will not be covered under
warranty.
P15: Low Voltage Threshold: This sets the voltage where the motor will automacally cut
o. (See Low Voltage chart)
P16: Not Applicable
P17: Cruise Control: Enables cruise control. With this enabled holding the CUR buon will
toggle the cruise control and braking will disable it
0 = Cruise Control O / 1 = Cruise Control On
P18: Speed display adjustment: This adjusts the displayed speed by a percentage to more
accurately show your current speed. Increasing this past 100 will increase the displayed
speed and decreasing will do the inverse. Default is 100%. Range 50% - 100%.
P19: Zero Pedal Assist - Turns on and O the Zero Pedal Assist Level. **Note** Zero Pedal
assist does not disable pedal assist at the zero seng.
0 = Pedal Assist starts at 0 / 1 = 1 to 3 or 5 levels.
P20: Not Applicable.
To Next Page
Loading...
Need help?
General
