pg. 5
4) Before you start exploring the app, navigate to the "HW Controllers" screen found by pressing
Options -> HW Controllers. The screen should look like the screenshot below. Everything on this
menu should be turned OFF, as the DSP-LF does not have any hardware controllers and leaving
these on can result in a distortion of frequency response (because nothing is connected to these
pins in the DSP-LF. Note: If you restore the DSP-LF to factory defaults, you MUST turn these
settings off again as they might be activated by the factory reset.
Notes about the iWoofer App
• When it asks to import presets from DSP, if you press yes, that means it will import the settings
currently set on device to your app. If you say no, it will use the default (or locally stored) settings
stored in the app. You will get this message if you make initial adjustments with one smart device
and then connect to the same DSP-LF with a different smart device.
• When the app says, "import preset is not success," that is a typo. It is actually successful.
• There are many features and settings to explore in the app, make sure to try them all.
To Next Page
Loading...