EasyManua.ls Logo

DB Drive NEO1.5K User Manual

DB Drive NEO1.5K
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Due to continuous improvement of the product the Specifications are subject to change without notice.
TM
DB DRIVE warrants any products purchased in the U.S.A.
from an authorized DB DRIVE dealer. All products are warranted to be
free from defects in material and workmanship under normal use and
service for a period of (1) year when the unit installed by an authorized
DB DRIVE dealer. Non-authorized dealer installed products carry a (1)
year parts and labor limited warranty. This warranty applies to the origi-
nal purchase only.
DB DRIVE will either repair or replace (as its option) any unit
that has been found to be defective and under warranty provided the
defect occurs within:
One (1) year if purchased through an authorized DB DRIVE dealer.
This limited warranty does not extend to units that have been
subjected to misuse, abuse, neglect, or accident. Products that in DB
DRIVE’s judgment shows evidence of having been altered, modified,
or serviced without DB DRIVE’s authorization, will be ineligible under
this warranty.
To obtain warranty service please contact your retailer or see
our website www.dbdrive.net for more details.
All warranty claims must be handled directly through the
authorized DB Research dealer they were originally purchased from
Question and Answer IconNeed help?

Do you have a question about the DB Drive NEO1.5K and is the answer not in the manual?

DB Drive NEO1.5K Specifications

General IconGeneral
Amplifier ClassClass D
Channels1
RMS Power @ 1 Ohm1500W
Frequency Response10Hz - 250Hz
Signal to Noise Ratio>90dB
Input Sensitivity200mV - 6V
Bass Boost0dB - 12dB @ 45Hz
Subsonic Filter10Hz - 50Hz
Power Output1500W
RMS Power @ 2 Ohms800W
RMS Power @ 4 Ohms500W

Summary

SAFETY PRECAUTIONS

Fuse amplifiers power wire at the battery

Fuse power wire within 12" of the car's battery for protection.

Make all ground wires as short as possible and at the same point

Minimize ground wire length and use a common grounding point to reduce noise.

MOUNTING LOCATION

POWER CONNECTIONS

Connect the amplifier to the car's battery

Connect the amplifier's +12V terminal to the battery using an in-line fuse.

Connect the ground terminal of the amplifier to the car's chassis

Connect the amplifier's ground terminal to the car chassis with a short, clean wire.

Connect the remote terminal of the amplifier to a switchable +12V source

Connect the remote terminal to the head unit's remote output or power antenna wire.

SIGNAL CONNECTIONS

SPEAKER CONNECTIONS

TROUBLE SHOOTING THE SYSTEM

Protection LED Indicator

Explains causes and solutions for the red protection LED indicator.

SPECIFICATIONS

NEO4 Specifications

Lists technical specifications for the NEO4 amplifier model.

NEO1.5K Specifications

Lists technical specifications for the NEO1.5K amplifier model.

Related product manuals