Need help?Do you have a question about the DB Drive EUPHORIA T265 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power @ 4 Ohms | 65W x 2 |
| RMS Power @ 2 Ohms | 95W x 2 |
| RMS Power @ 4 Ohms Bridged | 190W x 1 |
| Frequency Response | 20Hz - 20kHz |
| Input Sensitivity | 200mV - 6V |
| Signal to Noise Ratio | >90dB |
| Crossover Type | LP/HP/Full |
| Crossover Frequency | 40Hz - 400Hz |
| Bass Boost | 0 - 12dB |
| Bass Boost Frequency | 45Hz |
| Fuse Rating | 25A |
Essential guidelines for safe installation and operation.
Fuse the power wire within 12" of the car's battery for protection.
Be aware of vehicle components like gas lines and brakes when mounting.
Short ground wires reduce resistance and prevent ground loops.
Instructions for connecting the amplifier's power supply.
Use appropriate gauge wire directly to the battery's positive terminal.
Use a short, clean wire to connect the amplifier's ground terminal.
Instructions for bridging amplifiers, requiring a 4 Ohm minimum load.
Common problems and their solutions for amplifier installation and operation.
Checks for blown fuses, loose connections, and proper head unit settings.
Solutions for grounding, RCA cables, and charging system issues.
Identifies causes like speaker shorts, impedance, or overheating.
To Next Page
