Enter Setup
Exit Setup
3、Automatic Scanning Mode
In Automatic Scanning Mode，No manual trigger required，The sensor will automatically
detect the surrounding environment. When the scene changes, it will automatically trigger
reading. When reading is successful or exceeds one reading time, reading will
end.Whether the last reading is successful or not, the detection state will be re-entered.
（ Temporary switching Manual Mode by triggering the key during the sensing reading.）
Automatic Scanning Mode
Use aiming Aids
*Do Not Use Aiming Aids
*Temporary switching Manual mode
Do Not Temporary switching Manual Mode
The same bar code reading delay time
To Next Page
Loading...